|
USA-OH-BASCOM Κατάλογοι Εταιρεία
|
Εταιρικά Νέα :
- Surge Protection - an overview | ScienceDirect Topics
17 11 Theory of surge protection (insulation coordination) The insulation of a current-carrying system, machine or component is to provide it with the required insulation level (BIL) to withstand system voltages during normal operation, as well as temporary overvoltages (TOV) and momentary voltage surges, up to a certain level, during system disturbances
- Practical Grounding, Bonding, Shielding and Surge Protection
This book will allow you to gain practical skills and know-how in grounding, bonding, lightning surge protection Few topics generate as much controversy and argument as that of grounding and the associated topics of surge protection, shielding and lightning protection of electrical and electronic systems
- Selection procedures for surge protective devices according to the . . .
Surges due to lightning are the main cause of damage to the electrical equipment and the systems of surge protective devices (SPD) are the most widely used measures of protection For practical applications, the probability P SPD that an apparatus, protected by a given SPD system, will be damaged is a key point for its proper selection and installation
- A review of anti-surge control systems of compressors and advanced . . .
The parameter to watch, to control the surge, was a differential pressure (DP) through the flow measuring device by the source of a beam controlling the signal to the recycle valve and DP across the compressor The advanced performance and the high-stress-bearing compressors needed a high-quality surge protection system
- Protection against lightning overvoltages: Approach and tool for surge . . .
Overall performance of a surge protection device system in protecting apparatus against lightning surges IEEE EEEIC (International Conference on Environment and Electrical Engineering , Milan (Italy) ( 2017 ) , pp 7 - 9
- Vector surge estimation methods for loss of mains protection and an . . .
Vector surge and ROCOF protection algorithms for distributed generator islanding detection Mediterranean Conference on Power Generation, Transmission, Distribution and Energy Conversion (MEDPOWER 2018) ( 2018 ) , pp 1 - 6 , 10 1049 cp 2018 1918
- Surge arrester allocation for lightning protection of VSC based HVDC . . .
Surge arresters with a better protection rate consist of larger diameter metal-oxide resistors and therefore have a higher energy transfer potential Therefore, U pl U c , protection ratio, rated discharge current, and energy transfer capacity should also be taken into consideration when selecting a surge arrester or comparing products of different brands
- Surge Arrester - an overview | ScienceDirect Topics
From the above it is evident that material for non-linear resistance used in the manufacture of an efficient surge protection device must offer the least impedance during a discharge This is to provide a free flow to the excessive discharge current to the ground, on the one hand, and to draw a negligible current under normal system conditions, to make it a low-loss device, on the other
- Pressure Surge - an overview | ScienceDirect Topics
Without protection and with a flywheel, the flow curve is very steep, causing an extremely steep pressure drop Only with the surge tank is a slow, steady change of flow rate possible, resulting in a sufficiently flat pressure curve The necessary surge tank size is 50 m 3, with an air volume of 20 m 3 under operating conditions 4 3 7 1 2
- Surge arrester optimal placement in distribution networks: A decision . . .
For example, among the towers T 1 to T 4, towers 1 and 3 are left unprotected, while the remaining towers are equipped with surge protection By capturing and conducting the surge current, the SAs limit the voltage rise on the protected tower, preventing damage to the tower structure and the connected equipment [26]
|
|