|
Taiwan-MA-MA Κατάλογοι Εταιρεία
|
Εταιρικά Νέα :
- NTP: Common issues and troubleshooting - Cisco Community
ntp update-calendar: Global configuration command NTP usually changes only the system clock, this allows NTP also updates the date time info on the calendar The update will be done only if the NTP time is synchronized
- Solved: NTP update on the 3850 - Cisco Community
Hi I have a 3850 switch with NTP configured The connection to the NTP server was disconnected briefly but after the reconnect NTP hasn't syncroniced It would probably start to work if i remove and add the ntp server statement againt But are there any ways to get this to work again without recon
- ASR1002 ntp update-calendar not accepteed - Cisco Community
Hello , Recently we have upgraded from a cisco 7200 envirounment to an ASR1002 having to migrate the configs as well The command "ntp update-calendar" is not accepted in the config migration , any reason why ? doesnt the ASR have an internal hardware clock ? Any advice would be appreciated , Thank
- Catalyst 2960X XR シリーズスイッチで update-calendar . . .
2017年1月26日(初版) TAC SR Collection 主な問題 Catalyst 2960X XR シリーズスイッチで、以下のコマンドを実行しても、カレンダーがアップデートされない場合があります。 clock update-calendar ntp update-calendar この問題は CSCvb32325 として報告されております。 解決策 改修版ソフトウェア : CSCvb32325 の修正
- Solved: ntp - Cisco Community
switch(config)# ntp update-calendar 300 Do #sh ntp status to check the time sync on clients Also please note that NTP uses UDP port 123, so make sure that any firewall or access control lists within your isolated network allow NTP traffic between the devices
- cisco的时钟设定 - Cisco Community
system clock与system calendar分别 system clock system calendar system clock是基于软件的 system calendar是基于硬件的calendar不受开关机和重起的影响 通常他只被设一次 Manually Setting the Software Clock clock set hh:mm:ss date month year 时 :分: 秒 日 月 年 Month 必须是字母,不能是数字 Set the Calendar from the Clock or NTP clock update-calenda
- Cisco IE-2000 and ntp update-calendar
Hello! I configure NTP on switch IE-2000 but after reload, I see incorrect time date before switch synchronise time by NTP again What can I configure synchronisation local hardware clock with software clock like use "ntp update-calendar" command on another switches? Thanks!
- C1000-16P-2G-L Show Calendar displays wrong date and time . . .
NTP is setup and works flawlessly show clock displays the correct time and date After the calendar is set, the wrong date and time is displayed This happens with or without ntp update-calendar enabled Here are some commands: switch1#show run | sec ntp ntp logging ntp update-calendar ntp se
- Teacher’s Reference Manual - Cisco Community
Step 3: Configure routers to update hardware clock Configure R1, R2 and R3 to periodically update the hardware clock with the time learned from NTP R1(config)# ntp update-calendar R2(config)# ntp update-calendar R3(config)#
- Solved: ntp not working - Cisco Community
we have one switch cisco 3850 configured as a ntp master when we update another switch time form ntp server its update time but, its time is diffrent form our ntp master switch in ntp master we use just ntp master command and another switch we use ntp master switch loopback ip as a ntp server nt
|
|