|
USA-AZ-SELLS Κατάλογοι Εταιρεία
|
Εταιρικά Νέα :
- how does the anti-spin rear axle work? - RAM FORUM
The main drawback to an open differential is that torque is always split 50 50 Each wheel receives 50% of the input torque (ignoring losses) This means that if one wheel is in the air and it takes almost no torque, say 10 ft-lb , to turn the wheel, the other wheel will only receive 10 ft-lb of torque
- 2018 2500 humming droning in the front end? SOLVED!
That sounds exactly like a wheel hub (wheel bearings) As others have said replace them both at the same time I tried replacing one on my other trucks and it wasn't 2 weeks before the other side went out If you don't use the OEM, Precision Hubs (at O'Reilly Auto) make a really good wheel hub assy for these trucks
- Wheel Tire balancing on pre-War cars - Discussion Forums
But there was an element of danger in using it The adapter clamps which wedged inside the wheel were designed to hold a spinning steel wheel assembly, which snapped onto the wheel clamp via 4 lever clamps At one store in our area, a young tire-buster was trying to spin balance a wheel, and shifted his body position carelessly
- Any way to add rear-differential-lock-only switch on 1500?
Just about every modern car will use individual wheel braking along with overriding throttle control to try to prevent wheel spin, keep the car driving in the direction you've pointed the steering wheel and hopefully send power to whichever wheel has traction - the difference that BLD brings to the table is that it continues to work when you
- Pin Striping Disc Wheels - Technical - Discussion Forums
It worked OK, but I changed mine around I got a ~12" diameter "lazy susan" turntable from Home Depot, put an 18" diameter disc on top and placed the wheel on it I used the Corkins conical base and arm as a stand outside the wheel and adjusted the arm so that the striping tool could rest gently against the wheel surface
- G80 locking diff questions - Tahoe Yukon Forum
So I just discovered the original window stickers for my 1997 two door Tahoe Per the sticker and verified on the glovebox door I do have the G80 locking rear differential with 3 73 gears Original owner discussion and all paperwork received show no rear end service or repairs issues with
- Loud noise when in reverse and turning in the morning only. 2021 Yukon.
I assume rear differential as it is rear wheel drive, not 4 wheel drive Not sure replacing the rear differential will solve a problem in the right front If the noise is coming from the front of the vehicle I would say either front brake, wheel bearing or suspension issue from what little info has been presented
- Acts like Limited Slip but has OPen Differentials
Open differentials can spin both wheels provided they have similar traction The wheel hop you feel might be brought on by the traction control I have the LSD and sometimes get funny wheel hopping with the traction control on if I'm on ice snow The TC uses the ABS to slow a spinning wheel and force power to the opposite one
- 2016 ram 1500 rcsb build thread | Page 11 | DODGE RAM FORUM - Dodge . . .
well one coil was too much lol i think im going to put the stock spindles and belltech springs back on for now
- Rear wheel play in and out - source of clunk? | Page 6 | Chevy Tahoe . . .
I think I used the copper colored ones, they measured slightly thicker Yeah they seemed to just fall in 2Wd Seems like there is a tiny bit less endplay The g80 works If you spin one wheel slowly, the other spins the other way Sped up the spin, and it kicks back
|
|