|
Switzerland-YR-YR Κατάλογοι Εταιρεία
|
Εταιρικά Νέα :
- [Arm] SYStem. Up SYStem. Attach returns debug port fail
If the "debug port fail" error occurred after a SYStem Up command, test if SYStem Mode Attach then Break delivers the same error If you don't get an error, then the SYStem Up issue is probably related to reset options The target might be in an unrecoverable state Re-power the target and retry
- Lauterbach multicore debugging guide - STMicroelectronics
There is a possibility to debug dual-core processor with single TRACE32 PowerView window, but for better orientation and easier debugging there is the possibility to start multiple PowerView windows The term Single Device Solution is used if one Lauterbach device is used to debug all cores
- lauterbach - Trace32 - command lock on sys. gtl - Stack Overflow
You have to execute the SYStem GTL LIBNAME command on both GUIs before any of them executes SYStem Up or SYStem Attach
- PowerView Users Guide - Lauterbach
Command Line If you want to start TRACE32 via the command line of the operating system, you need to manually create the configuration file (by default config t32) The configuration file settings are described in “TRACE32 Installation Guide” (installation pdf)
- Attach function with Lauterbach - NXP Community
Run Lauterbach with t32mppc exe Now the status of Lauterbach is system down Touch ‘CPU’->’System Settings ’ The Mode item will change to ‘Up’ and status of Lauterbach is changed to running And close the SYStem window Then you can stop MCU and check code as usually
- [RH850] SYStem. Up SYStem. Attach returns debug port fail
The used JTAG clock might be too high (JTAG mode only) Try a lower JTAG clock using the command SYStem JtagClock e g SYStem JtagClock 1MHz If you are using LPD mode, then try different baud rate values using the command SYStem BAUDRATE or using the BAUDRATE pulldown menu in the SYStem window
- RISC-V Debugger and Trace - Lauterbach
Connect the host system, the TRACE32 hardware and the Debug Cable Power ON the TRACE32 hardware Start the TRACE32 software to load the debugger firmware Connect the Debug Cable to the target Switch the target power ON Configure your debugger e g via a start-up script
- General Commands Reference Guide S - Lauterbach
SIM TRACE32 Instruction Set Simulators 37 SIM AREA Selects area for simulation output 37 SIM BreakBeforeMake Switch read write breakpoints to break-before-make 38 SIM CACHE Cache MMU simulation and more 39 SIM CACHE Allocation Define the cache allocation technique 40 SIM CACHE Mode Define memory coherency strategy 41
- SYStem. Up or SYStem. Attach to debug boot process? - Lauterbach
TRACE32 is configurable to the maximum Thus, it allows its customers to create start-up scripts for any debug scenario during the boot process An important decision that the tester has to make is at which time to establish debug communication to the platform under debug:
|
|