|
- Very slow rotary turning near the outside diameter
Update I got the G93 post working But I’m still turning at the same slow speed It shows a feed rate of 11,000 instead of 240 but using my rpm gauge I’m still turning at the same speed So it’s like something in Mach 3 is not allowing the correct feed rate to be used Any help would be greatly appreciated rig gap Vectric Craftsman Posts: 173 Joined: Fri Jan 03, 2014 1:00 am Model of
- UCCNC Rotary Control - Page 2 - Vectric Customer
Don't remember when vectric included G93 ability but I think it would be after version 4 Mach3 had its own issues with rotary axis speeds too I remember working with Art Fennerty to sort out a couple of errors years ago Or maybe it was Brian Barker It was a long time ago and my brain is getting old Desperation set in
- UCCNC Rotary Control - Vectric Customer
G93 G1A360F45 (I put the G93 in there so someone does not "solve" my issue by saying "well you need a G93, there, problem solved") The UCCNC manual states that a rotary axis is programmed by the inverse time method (G93) No matter what value I change the F word to, the axis still runs at rapid Which is defined in the configuration screen in
- Rotary Rounding Toolpath - What am I doing wrong?
I am fairly new to using a rotary, but I haven't had an issue until now I have a 2" square blank that I am trying to round with the rounding gadget, but I can'
|
|
|