Viewing a thread - Straightening a bent forklift fork - AgTalk Have a Westendorf forklift attachment on my loader and recently bent the first first foot or so of the fork where it is the thinnest (fork on the right in the picture) Tried blocking the end of it up and driving over it with a MFD tractor but that did nothing Can it be bent back with a hydraulic press or will it break?
Straightening Fork lift Forks, Will it work?? - YouTube Hey guys, Here is another short video on our efforts to straighten s set of bent forklift forks Will it work? Will they break? Will they lose it's heat temper? Stick around and find out
Bending forks from a forklift question - Yesterdays Tractors If its bent at the tip you can get them cold pressed back Heating to soften it enough to bend will ruin the strength of the forks by annealling the steel You might be able to do some flame bending which is below the annealing temp but it takes patience It basically uses the steel growth with temp as a little jack to bend the other steel
Common Forklift Problems Solutions | Gregory Poole Lift Forklifts often lift loads in several stages, which can cause various issues Common mast-related issues include failure to lift or lower correctly, lifting too slowly and jerky lifting and lowering Steering issues: Forklifts can be a challenge to steer, especially if space is limited