|
- P0300 Random Multiple misfire - Nissan Forum | Nissan Forums
I'm not sure that made much of a difference in the symptom other than I now ONLY get a P0300 code The P0301 code has not resurfaced I'm inclined to replace the remaining coils (5) with new Hitachi coils and see if that solves the rough start and multiple misfires If I clear the code using the scanner it resurfaces quickly P0300)
- P0300 random cylinder misfire code with no symptoms?
Anyone ever deal with a P0300 code that keeps popping up after being cleared? The code is for "Random multiple Cylinder Misfire Detected" The code is for "Random multiple Cylinder Misfire Detected" I did some searching and it seems like this code is usually accompanied by other codes (O2 codes, crank cam sensor codes, etc ) which usually
- Cam shaft timing issue code P0014, P0300 - Nissan Forums
Got on the highway and now I had a steady MIL light but no wall on WOT downshifts Car seemed to drive fine even when I pushed I scanned it once back at home and got a P0300 (multiple random misfire) and P0014 (Cam shaft control solenoid B- Bank 1- timing over advanced) Cleared the code and car sat for a week
- P0300 Rough Idle VK45DE M45 - Nissan Forum | Nissan Forums
Took some effort Jack the car up and have it on jackstands Remove the underbody tray Remove the left front wheel Lower the A C compressor after removing the belt to get to the motor mount, jack the engine up with a piece of wood protecting the oil pan, remove the driver motor mount, use a combination o
- Lean Bank2 SHRTFT 25% and P0300 random misfire at idle
DTC code P0300 during idle only, BANK 2 SHRTFT(%) = 25 steady at idle The engine hesitates every 30 seconds exactly, when ----- upstream O2 sensor voltage rises to about 0 94v and ---- SHORT TERM FUEL TRIM SHRTFT(%) drops to 0 a- BANK2 emissions are abnormal I need help to diagnose root cause:
- P0300: After Ran Out Of Gas - Nissan Forum | Nissan Forums
First of all, I am back to P0300 code ONLY I've got the reading with my Bluetooth adapter, but I also went to my local Autozone to make sure Same P0300 Now, I've been thinking Since this all happened After I Ran Out Of Gas (and SeaFoam did not work either) most likely I have clogged Fuel Injectors
- P0300- diagnostic code indicates a random or multiple misfire.
When a P0300 shows up suddenly with no other codes, the prime suspect is always a bug in the MAF All it takes to make the engine run like crap is a piece of lint or butterfly wing, and since Nissans don't generally have MAP sensors for the ECM to cross-check the MAF, misfire codes are usually all you'll get (if any codes at all)
- QX56 P0300 multiple misfire… God Help me… - Nissan Forum
The injector wires for the odd bank all go through the same subharness connector from the engine harness, F60:F121 at the front of the left valve cover
|
|
|